BNDJP - K10 L40, TINTING COLOR TURQUOISE
- MSDS: BNDJP
- Manufacturer: SHERWIN WILLIAMS CO
- Product Name: K10 L40, TINTING COLOR TURQUOISE
- National Stock Number: 8010-00N029613
Product Identification
Product ID:K10 L40, TINTING COLOR TURQUOISE
MSDS Date:04/04/1988
FSC:8010
NIIN:00N029613
MSDS Number: BNDJP
Responsible Party
CLEVELAND, OH 44115
US
Emergency Phone: 216-566-2917
Info Phone: 216-566-2902
Cage: 54636
Contractor
Telephone: 800-251-2486/216-566-2242
Cage: 54636
Ingredients
0.0
CAS: 107-41-5
RTECS: SA0810000
Fraction By Weight: 1-60%
OSHA PEL 25 PPM, C
ACGIH TLV: 25 PPM, C
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:(ACUTE) IRRITATION OF EYES, SKIN AND
UPPER RESPIRATORY SYSTEM. IN A CONFINED AREA VAPORS IN HIGH
CONCENTRATION MAY CAUSE HEADACHE, NAUSEA OR DIZZINESS.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:REDNESS AND ITCHING OR BURNING SENSATION MAY
INDICATE EYE OR EXCESSIVE SKIN EXPOSURE.
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.
First Aid
First Aid:INHAL: IF AFFECTED, REMOVE FROM EXPOSURE. RESTORE BREATHING.
KEEP WARM AND QUIET. SKIN: WASH AFFECTED AREA THORO WITH SOAP AND
WATER. REMOVE CONTAMINATED CLOTHING AND LAUNDER BEFORE REUSE. EYES:
FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. GET MD.
INGEST: CALL MD IMMEDIATELY .
Fire Fighting
Flash Point Method:PMCC
Flash Point:>199F,>93C
Extinguishing Media:CO2, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
.WATER SPRAY MAY BE INEFT.IF WATER USED, FOG NOZZ PREF.WATER MAY BE
USED TO COOL CLSD CNTNRS TO (SUPP DATA)
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
BUILD- UP OF PRESSURE) WHEN EXPOSED TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AND
REMOVE WITH INERT ABSORBENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DOL STORAGE CATEGORY-3B.USE W/ADEQ
VENT.AVOID BRTHG VAPOR/SPRAY MIST.AVOID CONT W/SKIN/EYES.KEEP CNTNR
CLSD WHEN NOT IN USE.DO NOT TAKE INTERNALLY.
Other Precautions:THIS COATING MAY CONTAIN MATLS CLASSIFIED AS NUISANCE
PARTICULATES WHICH MAY BE PRESENT AT HAZ LEVELS ONLY DURING
SANDING/ABRADING OF THE DRIED FILM.TRANSFER ONLY TO APPRVD CNTNRS
W/COMPLETE & APPROP LABELING. KEEP OUT OF REACH OF CHILDREN.
Exposure Controls
Respiratory Protection:IF PERS EXPOS CANNOT BE CONTROLLED BELOW APPLIC
LIMITS BY VENT, WEAR A PROPERLY FITTED NIOSH/MSHA APPROVED ORG
VAP/PARTICULATE RESP FOR PROT AGAINST MATLS IN INGRED SECTION. WHEN
SANDING/ABRADING DRIE D FILM, WEAR A NIOSH/MSHA (SUPP DATA)
Ventilation:LOC EXHST PREF. GENERAL EXHST ACCEPTABLE IF EXPOS TO MATLS
IN ING SECTION IS MAINTAINED
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:WASH HANDS AFTER USING.
Supplemental Safety and Health
FIRE FIGHT PROC: PREVENT PRESSURE BUILD-UP & POSSIBLE AUTOIGNITION OR
EXPLOSION WHEN EXPOSED TO EXTREME HEAT. RESP PROT: APPRVD DUST/MIST
RESP FOR DUST WHICH MAY BE GENERATED FROM THIS PROD, UNDERLYIN G
PAINT/ABRASIVE. VENT: REFER TO OSHA STANDARDS 1910.94, 1910.107,
1910.108.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:>386F,>197C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:1.1-1.6
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:2-73
Stability
Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:BY FIRE: CO*2, CO.
Disposal
Waste Disposal Methods:WASTE FROM THIS PROD IS NOT HAZ AS DEFINED UNDER
RCRA 40 CFR 261. INCINERATE IN APPRVD FACILITY. DO NOT INCINERATE
CLOSED CNTNR. DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS REGA RDING POLLUTION.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.